Embertec Emberplug EPUSAV-ET-01 Guia de Instalação descarregar pdf (Página 12)

Changing settings for Active Powerdown using

the SmartSensor

Your Embertec Emberplug™ is equipped with a number of settings to suit

your lifestyle. You can set your timer to either 1, 2 or 3 hours, depending

on usage habits. This means the SmartSensor will ash after the set period,

warning of imminent power down. In every case you can continue using

your equipment by pressing any button on any remote control.

The default setting is 1 hour, which is aimed to maximise your energy

savings.

Follow these instructions to change Active Powerdown to 2 or 3 hours, (this

may be appropriate for longer movies or programs where remote control

activity is less frequent).

Once, then release1 hour (default setting) 1 time

Please make sure the sensor has ashed back 1, 2 or 3 times

To set the Active

Powerdown

timer to:

Press the button

on the

SmartSensor:

To conrm the setting,

the LED light on the

SmartSensor will ash:

1. Ensure your Audio Visual (AV) equipment is switched on.

2. Press and hold down the button on the SmartSensor rmly for 3

seconds, then release. The LED light on the SmartSensor will ash for

a few seconds as it enters Settings Mode.

3. As soon as the LED light on the SmartSensor has stopped ashing,

immediately begin to set the Active Powerdown to 2 or 3 hours, by

pressing and releasing the SmartSensor button, as per the table below.

Twice2 hours 2 times

Three Times3 hours 3 times

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Embertec Emberplug EPUSAV-ET-01 Guia de Instalação Página 12